Post-Construction Cleaning in Saskatoon
Construction dust is not ordinary dust, and that single fact explains why homeowners who try to clean up after a renovation end up doing it three times.
Drywall dust particles are fine enough to pass straight through a standard household vacuum filter. The vacuum picks them up at the floor and exhausts them back into the room, where they hang in the air and settle again over the next few hours — usually onto the surfaces you just finished wiping. Sawdust behaves similarly. Silica dust from concrete or tile cutting is finer still, and it is a genuine respiratory hazard rather than just a nuisance.
Why we use HEPA filtration and multiple passes
We use HEPA-filtered vacuums, which capture and hold the fine particles rather than recirculating them, and we clean in passes rather than in one sweep. The first pass takes the bulk. The second, hours or a day later, takes what settled out of the air after the first. The third is detail work. Skipping the wait between passes is the most common reason a post-reno clean does not hold.
We also work strictly top-down — ceilings and light fixtures, then walls and trim, then surfaces, then floors last. Any other order means finishing the floors and then dropping dust on them.
What a post-construction clean covers
- Sticker, label and adhesive residue removed from windows, appliances, fixtures and glass
- Paint specks, drywall compound and caulk scraped from floors, glass and hardware
- Inside every cabinet, drawer and closet — dust gets in even behind closed doors
- Light fixtures, ceiling fans, vents and returns cleaned out, not just wiped
- Window tracks, sills and frames — where construction grit concentrates worst
- All appliances inside and out, including behind and underneath
- Baseboards, door frames, switch plates and outlet covers
- Floors vacuumed with HEPA equipment, then mopped with the right product for the specific flooring
Renovation cleaning versus new-build cleaning
These are two different jobs and we quote them differently.
A renovation clean happens in a house someone is living in. The dust has had time and airflow to travel well beyond the work area — into bedrooms two floors away, into the furnace ductwork, into closets nobody opened. The job is as much containment and recovery as it is cleaning, and it almost always covers more of the house than the client expects. In a house built before 1990, test for lead paint and asbestos before the walls come open. Our older-home renovation guide sets out what Health Canada advises.
A new-build clean happens in an empty house, which makes it faster per square foot but far more detailed. Everything is new, so everything still carries labels, adhesive, protective film, manufacturing residue and the fine grit of construction. Nothing has been cleaned even once.
What the builder's clean actually leaves
Most builders include a clean before possession. It is a sweep, a wipe of visible surfaces and a vacuum — enough to hand over a house that looks presentable at a walkthrough.
What it reliably leaves behind is dust inside cabinets and drawers, residue in light fixtures and vents, grit in window tracks, adhesive on glass and appliances, and construction dust sitting in the ductwork waiting for the first time the furnace runs. Doing a proper clean on an empty house before the furniture arrives is dramatically easier than chasing that dust around a furnished home for the following six months.
New grout and new finishes
New grout looks perfect and is highly porous until it has been sealed. Getting it cleaned and sealed early is the difference between grout that stays light and grout that never recovers. New engineered hardwood, luxury vinyl plank and quartz all have specific first-clean requirements too — and most are still inside a warranty period that the wrong product can void.
Who books this service
Homeowners after a kitchen, bathroom or basement renovation. Builders and contractors handing over a completed project. Buyers taking possession of a new build who want it genuinely clean before move-in day. Landlords after unit renovations. Commercial tenants after a fit-out — see our office and commercial cleaning.
Renovation work is heavily concentrated in Saskatoon's newer neighbourhoods right now — Brighton for new builds, and Arbor Creek and Stonebridge for basement developments and first kitchen replacements.
Book a post-construction clean
Call or text 306-700-6576. Tell us the square footage, whether the home is occupied or empty, and what kind of work was done — drywall, flooring, tile and paint each leave a different problem behind.
After the construction clean, many clients move onto a recurring schedule to keep the finished space that way. See all our cleaning services.